SpaceX Starship & Orbital Launch Tower tỉ lệ 1:144

I'm sharing modified 1:144 scale models of SpaceX Super heavy - Starship

I recommend printing in PLA with a layer height of 0.2mm and organic supports for parts where needed. The model is intended for more experienced printers. Print the arms of the mechazilla as a whole, tilted at an angle of about 40°, laid into the organic supports. If you have a resin printer, I recommend printing the rudders and other small parts in resin.

FOR A BETTER OVERVIEW OF THE MODELS I RECOMMEND DOWNLOADING THE .ZIP FILES INCLUDED IN THE APPENDIX OF THIS PUBLICATION!!

The entire assembly is approximately 103cm in height and takes approximately 2.5 kilograms of material.

Also needed is some twine (for the steel cables) and instant glue, a few M3 screws for the moving parts and model paints for the heat shield of the boat. I then recommend bolting the whole assembly to the wooden base.

You can find the pieces for the orbital tower in the ZIP archive. More information on the attached links.

The authors of the original models are:

MikeNotBrick: https://www.thingiverse.com/thing:5908857 (Tower)
AstroNot: https://www.thingiverse.com/thing:5428967 (Ship)

I modified the models to form an optimal assembly and fit together, the ship has an added hotstaging ring of my own making.

Due to high demand, I decided to share the models publicly all under a Creative Commons - Attribution - Non-Commercial license

https://creativecommons.org/licenses/by-nc/4.0/

I have spent dozens of hours working on modifying the models. Have fun :-)

Please rate the model or add feedback :-)

EDIT: Thanks to Lawrence H for completing the model, specifically the parts leg_shields and water_delugue_1, water_delugue_2, I added the models of this author to the parts of the launching ramp