Bông tai Ếch (Frog Earrings)

Two frog earring designs based on designs by Anushka W, including Jeremy.

Both models are designed to be printed with a 0.2 mm nozzle at 0.1 or 0.05 mm layer heights. Because of the round features, 0.1 will look good but you should go as low as you feel comfortable. A 0.4 mm nozzle will work if scaled by 2x, experiment with different scales and nozzles for whatever best suits your printer!

The models in the picture were printed with a 0.05 mm layer height and painted. The round earrings used tree supports but should also work without supports. If you decide to paint them, I recommend using some sort of clear coat to protect them from regular use.

I used an earring kit from a popular online retailer, they all seem to have common parts so this should work with most earring kits. The holes in both models have a 1.0 mm diameter, so any thinner wire than that should also work!

Enjoy!