
Khay Gridfinity sắp xếp dây Apple Watch (Gridfinity Apple Watch Band Organizer)
- Downloads
- 558
- Likes
- 79
- Views
- 1,641
- Remixes
- 0
- Comments
- 0
Files 2 3.2 MB
- 4x2x3_Apple_Watch_Band_Case_1777334596.stlSTL · 1.1 MB
- 4x2x3_Apple_Watch_Band_Case_1777334597.stepSTEP · 2.1 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #346710
- Category
- DIY
- Published
Description
This is a presentation case for organizing your collection of Apple Watch bands. It fits into Zack Freedman's Gridfinity system.
It's optimized for compact and reliable storage while still showing off as much as possible of each band, for easy selection and access.
Naturally, the cases are modular: they are designed to fit neatly side by side in a dress drawer, providing a seamless display.
Each case can hold up to 8 bands. The grooves holding the bands are about 8mm wide, sized to fit almost all bands on the market. The grooves are 20mm deep on the edges, with a generous center cutout reducing the depth to 7mm at the center. The deeper edges provide secure support for each strap, but they still leave about half of the band fully out in the open.
The case fits into the Gridfinity grid using a custom design inspired by @grizzie17's Gridfinity Refined and @rekk's Gridfinity Refried. You can push 6x2mm magnets in the nice press-fit magnet slots, or use a thumbscrew for a more permanent attachment. The thumbscrews printed from @grizzie17's files will fit this model, too.
Printing Recommendations
These print fine without supports. I recommend using PLA; neutral colors work best.
The case is almost 17cm long. As usual with larg(ish) prints, if you have bed adhesion issues then you might get some warping, even with PLA. Enabling brims and/or using a glue stick can help in that case.
I like to print these with a 0.6mm nozzle and 0.2mm layer height, with 15% infill and 2 perimeters. In this configuration, each case prints in a little less than 3 hours on a Prusa MK4.
With a 0.4mm nozzle, I recommend using 3 perimeters to achieve solid walls between the grooves. (The smaller nozzle size increases printing time, but only by about half an hour.)
The samples pictured were printed in Protopasta's Empire Strikes Metallic Black. (Prusa Galaxy Black is also a great choice.)
Print spec
- Formats
- stepstl
- Model files
- 2
- Total size
- 3.2 MB
- Largest file
- 2.1 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-

-

-


