Đế sạc iPhone MagSafe Nightstand Mode (Charging Stand)

Description: This is a stand designed for an Apple MagSafe charger using Nightstand Mode the following iPhone models - in a case:

• iPhone 12/12 pro
• iPhone 13/13 pro
• iPhone 14/14 pro
• iPhone 15/15 pro

Compatibility notes:  I can't guarantee it will work for phones in all cases due to variation in dimensions, but I tried to make it forgiving.  This is designed for use with an Apple MagSafe charger only, as it is a press-fit into a very tight hole.

Printing Notes:  I printed the top portion of the charger in PLA using 40% infill for some heft.  The lower portion was printed in TPU with 20% infill.  

Assembly Notes:  

1. Thread the cable through the hole in the bottom of the charger.
2. Press fit the MagSafe disc into the hole.  Note that this is a very tight fit by design.  If it is too tight, you may want to scale the size of the charger slightly.  Also note that the disc does not fully recess into the hole - this allows space so the camera doesn't interfere with the charger top.  Turn it over frequently as you're pressing to make sure you're not trying to go further than the design allows.
3. Install the base by pulling extra cable through, and then gluing the bottom face of the top piece with plastic glue.  I recommend E6000.
4. Use weight to ensure the plastics bond, and wipe away any excess.

Let me know if you have any questions or comments!  I'd share my files, but I'm just learning Fusion 360, so I'm not too proud of the quality.