Chân Đế Loa (Speaker Stand)

Please share photos if you print it. Remixes encouraged.

WILL FIT 220 x 220 BEDS 

I'm using Adam Audio T7Vs. If you have 5 inch drivers you can scale all the parts down to around 75% to get similar look.

How to print

• The speakers have a connecting slot to keep them together and at a equal width apart.
• Print part on its side with the hole facing up for optimal printing.

Infill

• I used around 20% infill and matte overture PLA (Super strong but can be PETG and more infill if you want)

Post Print

• Nothing besides connecting it with the connector bracket. Glue is optional.

Print Settings

• Depending on printer will determine your settings, for best look go slow and low layer height, but you can do whatever you want. Just be cautious of warping since it will fill up most beds.