Daredevil (Netflix) Billy Clubs Remix

This is a remix of the Daredevil (Netflix) Billy Clubs. This remix has a holo tube on the inside designed to contain a wire like seen in some versions of the billy clubs. When opened, the wire is able to slide in and out of the tube. The wire can be wrapped into the small ball on either end to prevent it from slipping through the connector parts which have a hole smaller than the ball but big enough for the wire.

I've also added an alternate piece that can be used along with body2 to replace body1. This alternative piece will allow one side of the staff to open with a cord and the other to open without the cord. The one downside to this is that the cord must be half the length which is much shorter than many of the shots in the show. There's a small loop on one side of the alternate piece to allow the cord to go through a get tied on.

If you have any questions, feel free to message me, I'll try to get back to you as soon as possible.

Print Settings

Printer Brand:

Prusa

Printer: 

i3 MK2S

Rafts:

No

Supports: 

No

Resolution:

.15mm

Infill: 

20%

Filament:
Amazon Basics PLA Black

Category: Props