Skip to main content
F3D
Nút Bịt Ống (Hose Plug) 1
Nút Bịt Ống (Hose Plug) 1
1 / 1

1 image

DIY

Nút Bịt Ống (Hose Plug)

By RainAndStorm

Downloads
108
Likes
5
Views
619
Download all (.zip)· 5 files · 4.8 MB· 4.8 MB

Files 5 4.8 MB

  • Hose_Plug_-_0.5in_1777220256.stlSTL · 1.2 MB
  • Hose_Plug_-_0.75in_1777220257.stlSTL · 1.2 MB
  • Hose_Plug_-_1in_1777220258.stlSTL · 1.2 MB
  • Hose_Plug_-_1.5in_1777220259.stlSTL · 1.2 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#342038
Category
DIY
Published

Description

Quick way to seal a hose.  Each plug is long enough for two hose clamps.

Available sizes:

  • 1-½"
  • 1"
  • ¾"
  • ½"

Printing

No supports needed, but make sure to give it a nice brim.  100% infill is recommended.

Ideally should be printed out of something rigid, water-resistant, that can withstand direct sunlight without getting soft.

Optionally can be painted or covered with a layer of two of resin (epoxy, polyester, etc).

Read more Show less

Print spec

Formats
shapestl
Model files
5
Total size
4.8 MB
Largest file
1.2 MB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy