Double RepRack - Kệ lưu trữ filament DIY x2 (xếp 2 tầng cuộn)

DIY Doubled Up!

Remixed version of "RepRack" filament storage system that stacks 2 rows of Filament spools atop of each other. Designed to sit on a shelf or shelving unit. Uses 1/2" EMT conduit as the "Rack rails" of the system. Requires screws to install the clamps that retain the rack rails.

Requires additional hardware:

• Thread Cutting Screws
• M4 Hardware
• M3 Hardware
• M3 Heat Press Inserts
• 1/2" EMT Conduit

NOTE: Brackets are sizable and won't fit on an Ender 3 (or similar 235mm) bed. Measures 248mm x 208mm. Sized specifically to fit within a Prusa Mk3 / Mk4 build volume (also fits the Bambu X1 & P1P bed).

Parts Needed (Affiliate Links):

• 1/2" Conduit: https://www.lowes.com/pd/Common-1-2-in-Actual-50-In-Metallic-Emt-10-ft-Conduit/3129551
• M3 Heat Inserts: https://amzn.to/3LEMezN
• Polymaker Filament: https://tinyurl.com/Polymakerr

Files Included:

• Double RepRack STEP File
• Left Double Rack STL
• Right Double Rack STL
• Mid Double Rack STL
• M4 Clamp STL
• Thread Cutting Screw Clamp STL
• M3 Insert Clamp STL
• Double Rack Bracket DXF

Recommended Print Settings:

• 3 Perimeters
• 20% Infill
• No Supports Required
• PLA filament is generally fine for this application. If near hot components ASA or ABS would be preferred.
• Bigger nozzle sizes & layer heights recommended (.6/.8) but not required.

Want to Support what I do? Check out my social medias please!

Link Tree: http://www.MandicReally.com/links