Joint Bridge Clamp (Kẹp cân mặt ván) cho thợ mộc

Joint Bridge Clamp for woodworkers. Keeps Boards Level and Equalizes Clamping Pressure.

Pretty useful helper or a gift for a woodworker!

• Designed one side and both, (one side it's easy to print, and then printing in this position, it will be much stronger for pressure! But it's your choice)
• I recommend infill make 20-30%.
• Walls, bottoms and tops make at least 4 layers with 0.20 nozzle.
• No support is needed for one side, easy to print.
• PLA is ok, but for longevity recommend PETG.

That is all, if you keep these recommendations, then this clamp will serve for a long time!

Total width: 130mm, total height: 50mm, thickness: 40mm

P.S. The Last photo with red clamps is from the internet, it's just for example. This photo belongs to "Woodpeckers".