Skip to main content
F3D
Tháp Xúc Xắc Catapult (100% In 3D, KHÔNG CẦN SUPPORT) 1

3 images

Board Game

Tháp Xúc Xắc Catapult (100% In 3D, KHÔNG CẦN SUPPORT)

By sdaendi

Downloads
162
Likes
205
Views
2,613

Files 14 3.7 MB

  • straight_MULTIPLE_1777182156.stlSTL · 58.9 KB
  • straight_MULTIPLE_TIGHTER_1777182157.stlSTL · 66.5 KB
  • round_MULTIPLE_1777182158.stlSTL · 92.5 KB
  • triangle_MULTIPLE_1777182159.stlSTL · 93.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A dice tower where you have to roll the dice with a catapult. You can adjust the wall yourself so that the dice fall down the way you want.

I printed everything with a layer height of 0.2mm.

Everything is rotated correctly

If the cube spikes too far at the top, print the protection.

Improvements

  • To protect the cubes from falling out it has a new file "main" with higher margins than the normal one.
  • If the "straight" edges are too loose, it now has a new file with tighter edges.

Problems with the angle of the catapult:
If your catapult is too strong / weak you should check the angle. The rod is a hexagon, so when assembling you should make sure that the rotation is the same as in the picture (pay attention to the alignment of the square and the hexagon), then you should be able to align the catapult as in the cover picture.
If it is still too strong / weak, try a different filament for the feathers, not all filaments are equally strong.

Building instructions:
Attach the plate to the main with the 4 knobs, attach the catapult with the rod and attach the 2 spirals.

Read more Show less

Print spec

Formats
stl
Model files
14
Total size
3.7 MB
Largest file
1.5 MB

0 comments

See all