Giá đỡ Webcam cho Ender 3 V2 (Ender 3 V2 Webcam Mount)

Simple easy to print webcam holder for Ender 3 v2. The camera and connection to the printer should fit snugly but not impossible to fit. 

I have created two models each with different properties. The Andersson mount is closer to the middle of the printer and a smaller width for the hole for the webcam than the Logitech. See picture 4 as reference with the two models printed side by side.

Update 2023-01-18:

After high intense use and stress on the part made it to weak and broke. This have been “solved” by adding an aggressive fillet of 10mm at the point of breaking. Hopefully this solution will work for the future. 

AnderssonMount

Compatible with*****: 

• Andersson WBC 1.1

LogitechMount

Compatible with*****: 

• Logitech C920

*****I will add to this list depending on feedback from the communtiy. Test with your camera at home post a comment with what camera you use.

Print Settings

• Support: No*****
• Infill: 10%

     *****When printing slow the overhang where the connection point to the printer will start to            slack. There should be no problem printing without support but cannot guarantee 100%            success.