Mermaid Corbels - Đã sửa lỗi (Repaired)

I loved the look of these Mermaid Corbels (I didn't even know what a "corbel" was before I saw these!) uploaded by @darkside501st but when I went to print them, all three threw up errors in Cura, with the left being the worst. The left model was turned completely inside out! I imported these into blender, cleaned them up the best I could, and then let netfabb do the rest. I would have preferred to get these down to a single shell, but ... you have to balance time and effort with results.

For the best quality, print these upside down with supports enabled. I prefer Tree Supports in Cura. They are easier to remove and leave fewer scars.

I wanted to use these on an 8" shelf I put up so I added a stretched version of each that extends the upper ledge by 54.5mm. Then I was able to scale it up in my slicer as large as I could go - about 6-1/2" long. I reckon I'll use either Gorilla Glue or Liquid Nails to attach them.

@tato_713 made a great suggestion... you could use these as bookends, too!

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Rafts:

No

Supports:

Yes

Resolution:

0.1mm - 0.2mm

Infill:

20%

Category: Decor