
DIY
Hộp đựng nút tai (print-in-place)
- Downloads
- 118
- Likes
- 9
- Views
- 653
- Remixes
- 0
- Comments
- 0
Files 3 1.3 MB
- earplugs_container_1777133278.3mf3MF · 89.9 KB
- earplugs_container_1777133279.stlSTL · 291.9 KB
- earplugs_container_1777133281.blendBLEND · 987.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #338291
- Category
- DIY
- Published
Description
I recently bought new earplugs for band rehearsal and concerts. The enclosed container was of a very poor quality, so I decided to make my own.
It has a satisfyingly snapping lid and the entire thing prints in one go (print-in-place). The only place that require supports is the latch. No support is needed in or around the hinge on the back of the container.
It should be printed on the side (as it is in the 3mf file) to provide maximum strength for the latch.
Printing instructions:
- Print at 0.20 layer height
- PETG recommended for best latch bend properties
Print spec
- Formats
- 3mfblendstl
- Model files
- 3
- Total size
- 1.3 MB
- Largest file
- 987.3 KB












