Adapter bơm hơi CloudCuddle / adapter bơm diều (kite) / adapter bơm SUP

To be able to pump up the CloudCuddle bed for on the go, a special adapter for the air pump is needed, which is not supplied with the tent or pump anymore.

This connector solves the need to buy it seperately with shipping costs, etc.

Printing guidelines

• Do not make the print bed too hot, because this can create an “elephant feet” which might make it more difficult to get the connector in.
• Think about the seem, make this as small and smooth as possible (sometimes it may help to print the outer perimiter first)
• You could use a file to smoothen the seam if needed.
• Use organic support if possible (Prusa Slicer 2.6 Alpha or higher), which will make the support for the connecting overhangs easier to remove.
• Print in PETG, as this may be more resilliant then PLA.

Using a 0.6 nozzle might make it stronger and also faster to print ;-).
I filled up the perimeters on the 0.6 nozzle, so no infill needed and used 0.3mm layer height.

To test the connector, I printed another connector which should fit this one: https://www.printables.com/model/138899-kite-pump-adapter