Skip to main content
F3D
Đĩa an toàn cho cọc lều & groundsheet… 1

6 images

Thể Thao & Ngoài Trời

Đĩa an toàn cho cọc lều & groundsheet (TENT PEG GROUNDSHEET SAFETY DISK)

By PeterH

Downloads
551
Likes
330
Views
4,475

Files 1 372.5 KB

  • Groundsheet_Disk_1777107395.stlSTL · 372.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

If you haven't lost a tent peg or tripped over a peg slightly above the surface of the ground, or the edge of a ground sheet, you have no use for this model!

If you have, read on.

EASE OF USE

Simply hammer in the pegs as you usually would.  Just don't go nuts hammering on the print, it WILL break!

SAVES TEARS

There are the kind of tears you shed when your groundsheet tears (rips) - if you don't have an edged groundsheet, the disks will help spread the load if you peg though it, avoiding unnecessary fraying.

HOT TIP

I use shorter pegs (100mm) to deal with the hard ground we have here in Australia, and sharpen them to a point to make hammering them much easier

REMOVAL

If the peg is a bit stuck, don't lever it out, simply rotate the disk a couple of times to break the friction and they'll just pop out.

STACKABLE

The do disks take up space, but they click together to keep them tidy

EASY PRINT

I've used PLA, you  can use anything you like!  0,2mm layer heights will give a nice finish, the rest is up to you.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
372.5 KB
Largest file
372.5 KB

0 comments

See all