Tấm Đế Gridfinity Bắt Vít Có Nam Châm (Press-fit, Tháo Rời Được)

Remix on Plastic Flow's baseplate design.

The original design was my favorite base plate model except for one thing: you must glue the magnets in! It's also near impossible to remove them once they are glued in without damaging the base plate.

These now have press fit magnet holes, which are also removable if you push them out from the underside! Everything else on the original model was great, so these were the only changes made.

SETTINGS

Nothing special, whatever your favorite Gridfinity settings are. No supports needed, brim if you had bed adhesion issues.

PARTS

• m3 x 10 Screws
• m3 nuts
• 6 x 2mm Magnets

NOTES

Thanks to Plastic Flow for the original model! You can find spacers for these baseplates on their page!

Check out my 3D printing YouTube channel- Hot Plastic!