Giỏ pin 21700 cho Jumper T20 (5000mAh)

I actually bought the wrong size of the 21700 batteries, I did not know that the 5000mAh cell was physically bigger. Anyway, I designed this to fit the 5000mAh versions of the 21700 cells. You have to sacrifice the original battery basket to salvage the metal parts, wires and the connector. I also added a bit of thin tape around the cells before putting them in to the radio, just in case. The basket is a bit “flimsy” because it's a very tight fit, so when it's not in the battery-compartment it bends a bit because of the springs. But when inside the radio, it fits  like a glove. :)

I printed mine in PETG. But I'm guessing PLA will work as well. 
No support needed. :)

PS: The last picture is the original battery basket…