Catto Shelf Cat Shelf

Built in Onshape. I wanted to design my own stuff so I started here. Was inspired by people doing similar for their cats using planks and brackets, However I rent so screwing into the wall was not an option. also I didn't want to pay for wood when I have perfectly good cheap filament needing to be printed.

 I attached to the wall using command strips. Go overkill on them, I have about 12Kg worth of load capacity. Works great for my 4.5kg Cat. Bolted together with M8 nuts and bolts as that's what I had laying around. I used 65mm bolt which I don't recommend but the model was designed to accommodate them anyway.

Print wall attaching side down on the bed. I recommend brims as it can peel off the bed. Fit on a standard Ender 3. the Hexagons in the support buttresses do sag a little but a knife sorts that out. I used marine grade carpet and liquid nails to glue it down.  

Please Submit your cat photos! 

Also if anyone would like the model revised I can do that, I am very open to any ideas as I would like to design more obstacle for cats to adventure on and eventually have an entire system for everyone to print and enjoy, especially your pets.