Đèn Tea Light LED Organic (Print-in-Place)

Just a simple organic tea light.

Printing :

0.2mm layer height works well.

Layers and Perimeters:

Under Advanced set the Seam Position to Rear

Enable organic supports.

Please see screenshots below for the organic support settings that I used.

CAUTION: 

Please be careful that you don’t break off the first layer expansion of the support when you remove the lamp form the bed. DO NOT PULL AT THE BRANCHES! A sharp spatula generally works well to remove the first layer filament but be carful not to scratch your print sheet.

For security purposes, please ONLY use LED tealights over real ones. This model HAS NOT been designed to hold REAL Candle tealights!

I hope you will enjoy this lamp and may it bring a sense of zen into your home.

If you like this lamp, please check out my other creation: https://www.printables.com/model/626698-the-tree-of-light

Enjoy!

3D Model Usage Disclaimer

All 3D models provided by me are offered free of charge and are licensed under a Creative Commons license. These models are intended for personal and non-commercial use only. Resale, redistribution for profit, or inclusion in any paid product or service is strictly prohibited.

Any unauthorized commercial use or sale of my models constitutes a violation of the license terms and may result in a formal report, takedown request, and potential legal action. By downloading or using these models, you agree to comply fully with the stated licensing conditions.