Bambu G Duct

This is a print in place Bambu Lab Duct for the X1C, P1P, P1S, and P1E.

The supports are already added on the vent area and will need to be removed after printing. see photo posted

• A 3mf file has been provided painted and not panted version
• total grams used for this print is 12.76
• using the standard setting for Bambu it will print in under 1h

The model is scaled to ABS and ASA standards.

• it has been tested on a P1S and a X1C.

this model requires (1) 4x2mm magnets if you want the base to magnetize to the existing shroud.

please be aware that to install this you might have to gently remove some glue around the edge of the plastic. some shrouds and ducts are glued in place. also the two fasteners that hold the existing duct in place are meant to be reused on the new duct.

Why this duct. it centralizes the air around the nozzle and dose not blow the air to one side like the original duct. it also improves the overall localized flow. It uses Laminar flow to make the air more stable as it gets to the cooling area.

Special thanks to JoeMikeMakes for beta testing this on his X1C