Giá đỡ tua vít điện Fanttik cho Multiboard

Made this quick holder for my Fanttik Electric screwdriver (Nex S1 Pro) to attach to my Multiboard system.  I've designed it so that the top cap of the case is put on the bottom, leaving the USB charging on the top open and useable.  Fits perfectly with the top cap on the bottom. (though probably useable otherwise)

This is meant to screw into a multiboard grid hole, no extra parts needed. Note that the screw goes about 8mm past the grid and should snug up against the wall (though its probably not exact, it works and gives the holder a little extra stability)

Nothing special regarding print settings, just standard settings i use with Multiboard stuff.

0.20mm Layer Height
0.4 nozzle
3 walls/perimeters