Skip to main content
F3D
Đèn LED hình dạng bút chì từ PELARBOJ
Ý Tưởng Khác

Đèn LED hình dạng bút chì từ PELARBOJ

By PontusK_3906

Downloads
45
Likes
17
Views
274

Files 6 8.1 MB

  • mainbody_1765514998.stlSTL · 234.2 KB
  • Insert_USB-C_V2_1765515003.stlSTL · 267.1 KB
  • Base_USB-C_v7_1765515009.stlSTL · 218.8 KB
  • LightBlocker_1765515012.stlSTL · 247 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Immediately after seeing PELARBOJ, I started thinking and planning. I wanted to create something similar to it. After a few iterations, this is my result.

Bill of materials:

  • 1x Adafruit NeoPixel 16 LEDS 44.5mm diameter.
  • 1x USB-C port (panelmounted JRC-B008), I got 10pcs at Aliexpress for cheap.
    • There is an alternative version of the base and insert that takes a circular 5.5 mm x 2.1 mm DC jack. Will add that soon as well.
  • 1x ESP8266 D1 mini.
  • A few short cables, preferably black, red and some other color.

Printing the parts:

  • Main body, print in vase mode. Use material that lets light trough.
  • all other parts, print like normal.
    • Use brim on all parts except Base and Insert.
    • Use material that lets light trough for the top.
  • Use support on the insert.

Assembly:

Read the PDF for instructions with imaged, or read below.

  • Solder a red wire to the USB-C terminal labeled “V”.
  • Solder a black wire to the USB-C terminal labeled “G”.
  • insert the USB-C jack in the base and secure it with two screws (came with the terminal).
  • Prepare the ESP8266:
    • Connect the ESP8266 to your PC and navigate to install.wled.me and follow the instructions to install WLED on the board.
    • Solder a red wire to 5V.
    • Solder a black wire to GND.
    • Solder a third wire to D4.
  • Insert the ESP8266 in the base.
  • Add the insert, have the cables from the ESP8266 coming out in the center.
  • Add the NeoPixel ring to the insert.
  • Solder the following on the NeoPixelring:
    • Solder both black wires to “power signal ground”.
    • Solder both red wires to “power 5V DC”.
    • Solder the last wire to “data input”.
  • Insert power and make sure the installation works.
  • If all is ok, add the top to the main body.
    • The fit can be very tight if printed in PLA, but some heat to the parts will help.
  • Insert the main body and top in the base.
  • Attach the light blocker to the main body, use some glue if preferred.
  • Insert the USB-C/power-cable.
  • Enjoy!

Read more Show less

Print spec

Formats
pdfstl
Model files
6
Total size
8.1 MB
Largest file
6.5 MB

0 comments

See all