Chân đế Dell OptiPlex Micro (kèm khay giữ PSU)

This model is a storage solution for the Dell OptiPlex Micro (pictured is the 7080) PCs, allowing it to stand vertically, and neatly store the PSU and cable. There are accomodations made for the silicone cable strap, so you don't need to cut it off. There is also a storage holder for the plastic pip in the silicone strap. Remove the plastic piece from the strap and clip it into the holder inside the spool.

Print 1 of each STL file. Use M3 threaded inserts (5mm diameter, 4mm deep) and M3x6 machine screws everywhere, except for attaching the foot. Use M3x20 for the inner screws, and M3x10 or M3x12 for the outer screws. 

The F360 source file is included in case you want to change the screw sizes or dimensions. 

WARNING: This model requires you to drill 5x 3mm holes in the top case. You should use a centre punch to make sure the holes are drilled in the correct places. Put a small book under the top case when hammering so it doesn't get deformed.