Giá đỡ Native Instruments Maschine Mikro mk3

This model will support the NI Maschine Mikro mk3 on your desk, holding it up at a 20-degree angle in order to better see the LCD screen and buttons, and also making it a little more ergonomic for finger-drumming at arms-length.

The linked model designed for the mk1 version was a great start, but a minor annoyance encouraged me to edit the model a bit more. I slightly changed the gap between the front and rear cradle arms to more closely match the mk3 while leaving space for a couple 3mm EVA foam pads on each end, plus a couple mm extra wiggle room. I also lowered the height of both arms, particularly the rear arm so it doesn't obstruct the USB port when the stand is positioned directly under the device's built-in rubber feet. I also recommend gluing a couple additional foam or rubber pads on the underside of the stand to act as non-slip pads.

A pair of these will fit on the MINI printbed if they're arranged just right. I used [Polymaker Silk PLA - Silver] with PrusaSlicer's [0.25mm - DRAFT] preset and it came out great.

I've uploaded bgcode to print a pair on the MINI, my PrusaSlicer 3mf project file, my blender project file where I edited the model and cleaned up the geometry, and an STL exported from blender.

Thanks to jl_mayar for the great model to start from. Hope this remix helps someone else. Happy printing!