Nắp che Webcam Logitech C922 dạng trượt (Slide to Open)

This is a "Slide-to-open" friction-fit webcam cover for the Logitch c922 webcam.

It prints in three pieces and "snaps" together. It does not require any glue or other adhesives. It is also sized so that it does not cover the blue "camera-is-active" lights.

Assembly can be a little tricky. I have made 4 of these now and this is the method that I find works the best.

1. Seat the switch on the "rails".
   • Insert the "switch" end, or what would be the bottom, first.
   • You may need to bend the bottom part of the base rail out a little to get the switch to "snap" into the bottom rail
   • Align the switch part over the hole
   • From the front, put your finger through the hole and push the switch part away from the base.
   • While doing this, press the top of the switch part toward the top rail, effectively curving or bowing the switch part until it "snaps" into place
2. Once the switch part is in place and moves freely, insert the cover part
   • Looking at the back of the base, move the switch to the right (closed position)
   • place the cover part into the base's "channel" to the left of the switch part. Make sure that the indentation on the cover part is facing the switch part.
   • slide the cover under the switch and rotate it to align the indentation to the switch until it "snaps" into place
3. Simply friction fit the cover to the front to the webcam. Slide it left or right to make sure it is centered.

VERSIONING NOTES

Version 2 has a slightly larger opening and a longer witch handle. Thanks for the suggestion SimplyDuckers

Category: Camera