Mod Enclosure cho Ender V3 (KE/SE): Dời Dây Hot Bed (Hot Bed Cable Mod)

This is common with most 3d printers, The Hot Bed Cable comes out at a right angle from the printer interfering with the enclosure.

Base and Cover are a remix, I cannot find the original source (Sorry).  I increased the height and instead of having it separated from the extension, I built one in. I will provide two base files, one that doesn’t require the washers and one that does. The reason for the washers is I wasn’t happy with PLA touching the bed, so these provide a bit of insulation. I just used motherboard screw washers! Screwed them on first and proceeded with installation.

The cable guide roller is my design. I wasn’t happy with the cable hitting and rubbing on the base of the printer. Eventually something will give. It is print in place.  I used 3M 1mm thick double sided tape and attached it to either side of the middle screw. No problems with resistance over the whole hot bed, so it does not limit your print size. (See PDF for full instructions)