
Mô-đun tải trọng và cánh cho tên lửa nước thử nghiệm
Remix of Bộ phóng tên lửa nước in 3D với thiết kế linh hoạt By marimolabs
- Downloads
- 405
- Likes
- 52
- Views
- 3,270
- Remixes
- 0
- Comments
- 10
Files 15 2.6 MB
- Payload_RunCam_A_v0.11_1766321643.3mf3MF · 317.2 KB
- Payload_DPR_Base_v0.24_1766321643.3mf3MF · 319.1 KB
- Payload_DPR_Rotor_v0.21_1766321644.3mf3MF · 343.5 KB
- Payload_DPR_Delay_Hex_4mm_1766321645.3mf3MF · 15.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #32940
- Category
- Giáo Dục
- Published
Description
Early development prototypes of 84mm payload modules designed for the Simple 3D-Printed Water Rocket Launcher project. Siloed from main project until designs are mature.
Designs for 0.5L Polar Seltzer bottles are found separately here.
Currently in development
- Camera Module for RunCam 4K for lovely on-board video
- Delayed Parachute Release Module that uses Silly Putty (or duct sealing putty or plumber's putty) to release the nosecone 2-3 seconds into flight
- Universal Threaded Fins
Further details will be posted as developments warrant.
Print and assembly instructions TBD.
Please contact me if you are interested in helping with testing.
Disclaimer
Hey. Pressurized systems are dangerous. Know what you are doing and take appropriate safety precautions. Make your own assessment about whether this project is appropriate for what you are trying to do, and use at your own risk. Do not attempt without appropriate experience, protective equipment, and tools. Most water rocket guides recommend not pressurizing past 60psi/4 bar. Always secure the launcher to the ground.
Also: these designs are early alpha prototypes. They have high likelihood of failure and will likely smash your rocket and camera to pieces.
Changelog
2023-09-27: Fins Threaded Universal v0.05 posted. Untested.
2023-09-18: Deprecated Aerodynamic Parachute Release. Remains untested, but by analysis is unlikely to be reliable.
2023-08-30: New DPR versions validated with flight test x2. Base 0.24, Rotor 0.21, Nosecone Ring 0.20, Screw 0.1, Putty Cover 0.10.
2023-08-20-ish: Initial upload
Delayed Parachute Release v0.24 Video - August 2023
Latest version has replaceable delay hubs to replaced fixed spiky hub.
Print spec
- Formats
- 3mf
- Model files
- 15
- Total size
- 2.6 MB
- Largest file
- 343.5 KB












