Giá đỡ Macbook (Macbook Stand)

Simple stand for the M1 MacBook Pro. It'd work with any of the newer M models and the MacBook Air too too. The max thickness it'll fit is 19mm.

I recommend printing it with supports and rotating the model 10 degrees on its base. This way, the top surfaces will be flat and have a better finish, with the worst surface at the bottom where it's not visible.

There's models that use less material out there, but this one is sturdy and it's very hard to tip over because of the angle the laptop sits. Yet, the visible portion of the stand is minimal from the front.