Skip to main content
F3D
[AIRSOFT] Magwell VFC HK416A5 cho PTS EPM 1

6 images

Thể Thao & Ngoài Trời

[AIRSOFT] Magwell VFC HK416A5 cho PTS EPM

By RADprints_2540707

Downloads
108
Likes
16
Views
830

Files 1 199 KB

  • Magwell_HK416A5_1776881349.3mf3MF · 199 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

(Pardon my english, I am not a native speaker)

Tired of wobbly PTS mags in your magnificent 416 ?

Here is a solution !

This magwell will hold your mag in place and preventing it from oscillating from right to left into the pew's magwell.

------------------------------------------------------------------------

Printing advices

Stick the wider side (bottom) to the bed and enable supports for the “rails” visible inside the part.

I printed mine in ABS but I think other material will be suitable.

------------------------------------------------------------------------

Installation

Put the rear (open side) of the magwell against the pew's magwell and carefully widen the opening, allowing the piece to glide toward it's final position.

Be gentle, I broke some of my versions by applying to much strength. And pey attention to the “trench” on the left side of the pew, you will need to reopen the magwell a little bit.

Now you might have reached the end of the pew's magwell and each side of the printed piece should be in contact with each-other.

It might stay in place without any futher steps but you can secure it and adjust the retention of the mag by adding a M3x16mm SHCS and an adapted nut.

------------------------------------------------------------------------

ENJOY :)

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
199 KB
Largest file
199 KB

0 comments

See all