Skip to main content
F3D
Kẹp RJ45 Ethernet 2 phần – cố định/sửa tab gãy 1

1 image

Dụng Cụ Tiện Ích

Kẹp RJ45 Ethernet 2 phần – cố định/sửa tab gãy

Remix of Kẹp cáp Ethernet 2 chiếc có thể cắm vào By OldLady

By AlwaysKeen

Downloads
448
Likes
56
Views
1,346

Files 2 188.6 KB

  • lan-clip-1b_clip_1776870703.stlSTL · 51.7 KB
  • lan-clip-2b_base_1776870704.stlSTL · 136.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a problem that has plagued me for over 20 years. I was so pleased to see several 3D printed solutions. Unfortunately the original design by guss67 typically requires supports. To combat this there are designs that print in the wrong orientation. Or there is Old Lady's 2 part solution. I like it the best but it can slide backwards, which can be a problem when storing cables.

I've taken inspiration from another design and increased the bottom lip which presses against the bottom of the ethernet plug and prevents the print from sliding back. My remix creates a solid repair without needing glue or supports, and allows the flexible clip to be printed flat for optimal strength.

To assemble, slide on the base with the cut-out facing towards the rest of the cable. Then tilt the rear end up and slide the clip through till it locks into the base, slide the interlocked pieces back till it stops, and finally push the clip down locking everything in place.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
188.6 KB
Largest file
136.9 KB

0 comments