
Giá đỡ quạt 5015 tối giản cho BIQU H2
- Downloads
- 224
- Likes
- 33
- Views
- 1,888
- Remixes
- 1
- Comments
- 0
Files 1 8.2 MB
- 5015_H2_1776852983.stlSTL · 8.2 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #326431
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
The BIQU H2 is all about being as light and compact as possible. This fan mount has the same design criteria.
Prints best with a 0.4mm nozzle and in PETG, the extruder motor gets quite hot during use and it might melt ordinary PLA. Layer height should be 0.2-0.3mm. I recommend supports under the sharp splitters as shown using support enforcers.
Two short M3 screws are needed to fasten the mount to the extruder. The fan sits tight without fasteners but there is a hole for a 4mm fastener if required.
The motor on the extruder has to be rotated so that the wires do not interfere with the fan mount.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 8.2 MB
- Largest file
- 8.2 MB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-

-

-

-

-

-



