Đế sạc AirPods

Remixed from CarlTheCreator's AirPod Charge Dock. Took 20 mm off the back so that the AirPods case could open while charging. Rotated the thing 126.5 degrees to make it sit flat on the print bed.

Put some small 3M Command Strip adhesives on the bottom to undock with one hand.

Print instructions

Category: Audio Print Settings

Printer Brand: Wanhao

Printer: Wanhao Duplicator i3 V2

Rafts: Doesn't Matter

Supports: No

Resolution: 0.2 mm

Infill: 25%

Notes:

CarlTheCreator recommended printing at 101% size. I found that the official Lightning cable fit just fine at 100%, and at either size, I had to use needle nose pliers to remove the cable.