
Giá đỡ camera Prusa MK4 cho webcam Logitech C270/C310
- Downloads
- 774
- Likes
- 185
- Views
- 5,957
- Remixes
- 6
- Comments
- 57
Files 10 4.5 MB
- x-axis-base-v1_short_0.4n_0.2mm_PETG_MK4_59m_1765660963.gcodeGCODE · 1.7 MB
- camera-arm-v1_and_clamps-v1_0.4n_0.2mm_PETG_MK4_1h5m_1765660964.gcodeGCODE · 2.2 MB
- x-axis-base-v1_short_1765660955.stlSTL · 70.6 KB
- camera-arm-v1_1765660956.stlSTL · 81.1 KB
Make a variant with AI
Build another version of this model.
Remix versions 6
Ngàm gắn camera cho Prusa MK4 dùng Logitech C270ByEmjay_86080 · 05/03/2026
Case và ngàm gắn ESP32-CAM cho máy in Prusa Mk4ByJPGuitars · 04/09/2026
Tay đỡ Logitech Brio 101Bylandrevj · 07/04/2025
C270 Cánh Ngắn cho Giá Đỡ X-IdlerByVincent · 04/01/2025
Details
- Model ID
- #32567
- Category
- Máy In 3D
- Published
Description
Having a 3D printer without a camera is like driving at night without lights. I decided to create a base that doesn't require any alteration to the MK4 and can also serve as a starting point for others to create their own camera support.
What you need
- PETG filament (PLA is a good replacement)
- One M3x25 screw
- One M3x18 screw
- One M3 nut
- A Logitech C270 or C310 webcam
Printing Instructions
- Filament used: Prusament PETG
- Nozzle: 0.4
- Layer height: 0.2
x-axis-base-v1_short:
4 perimeters, 5 bottom solid layers.
camera-arm-v1:
3 perimeters, 5 bottom solid layers, support enforcers (see image).
cable-clamp-v1:
3 perimeters, 5 bottom solid layers.
FYI: These parameters are the ones I prefer, but the ones that come by default still work perfectly.
Assembly:
- Screw the camera to the arm using the M3x25 screw, no nut is needed on the other end. Do not over-tighten.
- Guide the cable through the rear slot of the arm and slide a couple of c-clamps to secure the cable.
- Attach the base to the arm using the M3x18 screwand nut.
- Place it on the printer as shown in the photos, the base should snugly fit to the x axis idler (right side).
- Adjust the camera's framing and gently tighten the screws.
- Attach the last c-clamp to the base.
- Enjoy!
Some inspiration was taken from:
Print spec
- Formats
- 3mfgcodestepstl
- Model files
- 10
- Total size
- 4.5 MB
- Largest file
- 2.2 MB
57 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-
New -

-

-


