Vasemode Trashcan - Thùng rác để bàn in vase mode

This small desk trashcan was designed to be printed in vase mode. The model has a size of 204x204x250mm and should fit on most 3D printers. 

Important⚠:

The model must be printed with a .6mm nozzle. Other nozzle sizes will not work cause of the way the model was designed. For the same reason, the model also can not be resized. 

Print setup:

To print the model, you have to modify your slicer settings. The following settings are for PrusaSlicer; I couldn't get this to work in Cura.

• Layer height: .3mm
• First Layer height: .35mm
• Layer height limits: 
  • min: .3mm
  • max: .3mm
• Spiral vase: yes
• Infill: 0%
• Perimeters: 1
• Bottom layers:  8
• Top layers: 0
• Extrusion width: .6mm
  • Default
  • First layer
  • Perimeters
  • External perimeters
• Slice gap closing radius: 0mm
• Extrusion multiplier: 1.03

The model works great in PLA but can also be printed in PETG. For PETG I would recommend to set the Extrusion multiplier a bit higher. 

Happy printing 😎