Skip to main content
F3D
Magnetic Tiles Haunted House: Miếng Sàn/Mái Phẳng 1

8 images

Giáo Dục

Magnetic Tiles Haunted House: Miếng Sàn/Mái Phẳng

By 3dpmom

Downloads
133
Likes
47
Views
849

Files 5 1.2 MB

  • Magtile_150x150_floor_1776830843.stlSTL · 304.6 KB
  • Magtile_150x150_floor_with_center_magnets_1776830845.stlSTL · 309.3 KB
  • Magtile_150x75_floor_1776830846.stlSTL · 237.8 KB
  • Magtile_75x75_floor_1776830847.stlSTL · 231.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Here are the floor and/or flat roof pieces for the magnetic tile haunted house. I designed these to be used with 20x5x2 and 10x5x2 neodymium magnets.  I strongly recommend using these size magnets. If you go larger it may not allow the magnets to rotate within their chambers. 

PLA Filament

Layer height 0.2mm

Infill 15-20%

Neodymium magnets needed: 20x5x2 and 10x5x2.

Magnetic build plate highly recommended but not absolutely necessary.

I recommend brims for the larger pieces (150x75 and 150 x 150) as a precaution to prevent warping on the corners).

For all of these pieces, add a pause print at layer height 6.0mm to insert the magnets. When the print is paused insert the magnets.  I like to alternate these two size magnets between the magnets holes (20x5x2, 10x5x2,20x5x2, 10x5x2, etc.).  I found if I used all 20x5x2 they were too strong and if I used all 10x5x2 it felt a little too weak.

After the magnets are inserted, resume the print. That's it:)

Here is a link to Amazon for the magnets needed for these pieces.

https://www.amazon.com/shop/3dpmom

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
1.2 MB
Largest file
309.3 KB

0 comments

See all