Bộ Body kit “Micron” cho Nerf Pro Sender

these parts all print flat on the build plate, except for the sights which print standing up. everything screws together with standard dart zone or nerf screws, and can be glued together for extra strength (muzzle goes inside of barrel, goes inside of carry handle. remember that order). In order to install, you will need to remove the right muzzle piece, which is solvent welded. After that you will need to do some minor shell cutting around the top opening to get it to fit. And finally after that you can close your blaster back up and appreciate the sender for the proper bullpup it should have been all along.

 Print at 4 walls (6 top and bottom), .24 max layer height (.16-.12 preferred), 15% infill. requires 7 screws.