
DIY
Ngàm gắn góc cho Aqara Presence FP2 (Corner Mount)
- Downloads
- 518
- Likes
- 32
- Views
- 4,345
- Remixes
- 0
- Comments
- 0
Files 3 273.2 KB
- Aqara_Presence_FP2_corner_mount_1776814964.stlSTL · 50.2 KB
- Aqara_Presence_FP2_corner_mount_V2_1776814965.stlSTL · 48.8 KB
- Aqara_Presence_FP2_corner_mount_V3_1776814965.stlSTL · 174.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #324515
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
Simple corner mount for Aqara Presence FP2.
Assembly
- Insert metal circular plate from Aqara Presence FP2 box (good enough fit, no glue necessary as it will be hold by magnet anyway)
- Glue double side 3M tape on areas touching the wall or screw with M3 screws (V3)
Print and post-processing instructions
- Everything else does not matter (no supports needed, I printed from PETG and with 0.6 mm nozzle).
- Surfaces touching the wall must be smooth, use sandpaper. Otherwise ducktape will eventually lose it's strength (after couple of days).
Features
- Holding Aqara Presence FP2 on a corner of the wall :)
- If you'll push out circular plate when mount is on the wall, it will not drop on the floor by will be catched by mount.
- Cable can be led behind the mount (between wall and mount).
Differences between versions
V3 is adding holes for M3 screws as I got cat and glueing is not cat resistant :)
V2 has significantly bigger surfaces touching the wall against V1. This makes duck-tape hold better (I have it duck taped for a month and still holding…).
Print spec
- Formats
- stl
- Model files
- 3
- Total size
- 273.2 KB
- Largest file
- 174.2 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-

-

-

-
New

