Skip to main content
F3D
Hộp khẩn cấp cho đầu tuýp 10 mm 1

4 images

Đồ Gia Dụng

Hộp khẩn cấp cho đầu tuýp 10 mm

By Dokkie

Downloads
171
Likes
179
Views
3,675

Files 17 4.5 MB

  • socket_holder_1776809009.3mf3MF · 36.4 KB
  • signs_1776809010.3mf3MF · 68.4 KB
  • sign_emergency_1776809011.stlSTL · 90.7 KB
  • sign_10mm_1776809012.stlSTL · 43.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is small project for emergency box for 10 mm socket. I've bought this emergency key box. They aren't very expensive (deppends on a store) and it's much more easier than making whole box. Maybe looks nicer too. The box is 120 x 150 mm.

The socket si hold by a 10x10x10 mm cube magnet, which is printed in. It's what I had on hand. The holder is stuck to the box by a glue. 

Socket measurements are on one of the pictures.

Printing instructions

Material: PLA

Layer height: doesn't matter, just deppends how thick do you want the letters. They are 0,4 mm thick so ideal for 0,2 mm layer height. 

Infill: Some

Brim: Without on the letters

Add layer change, so you can put it magnet! 

Assembly instructions 

Socket holder

You just need to put it in place with a glue. Better something thicker, I used aquiristic glue (it hold on everything) but something silicon based should do the job. Because the metal isn't very flat so it needs to fill the gabs. Also it's good to put in the hammer in the hole and the aligning will be easier. 

Signs

After printing, don't peel it off! Stick paper tape on it and slowly peel it off so it stays on the tape. Then just align it and stick in on there. Then you just need to peel it bit by bit, add glue, and you'll have straight lettering!

Read more Show less

Print spec

Formats
3mfgcodeiptstepstl
Model files
17
Total size
4.5 MB
Largest file
1.2 MB

0 comments

See all