Trang phục DUMMY 13 - Green Lantern (Hal Jordan)

The Emerald Knight, now in plastic!

This is my Green Lantern variant of the Dummy13 figure by soozafone 

I used the 2x Muscled arm for dummy13 and the Hunky variant

Note, all of my Dummy 13 models are printed at 150% and I doubt you'd be able to print a lot of these details at 100%.  You've got to have a well-calibrated printer to print dummy 13, and these parts are no exception. Some parts will need supports, but it probably depends on your printer, and its up to you to know your printer.

To assemble, press the emblem into the chest insert, and the insert into the chest. For the mask, the eyes press into the mask, the mask into the head. If any of it is too loose, use superglue. The hair has to be glued onto the head.

Parts:

• Green
  • Frame:
    • frame-abdomen
    • frame-chest
    • 2x Hunky_clavicle_2mm_added_for_hip_armor
    • 2x frame-ankle
    • 2x frame-shin
  • Armor
    • GL_mask
    • GL_emblem.stl
    • GL_chest (may need supports)
    • GL_abs
    • 2x armor-shin
    • 2x armor-foot
    • 2x armor-toe
    • 2x armor-hip (for hunky shoulders)
  • Lantern.stl (optional)
• Black:
  • Frame
    • frame-hips
    • 4x frame-knee-elbow
    • 4x frame-hip-shoulder
  • Armor
    • armor-crotch
    • armor-waist
    • 2x armor-hip
    • 2x armor-thigh
    • Either 2x armor-upper-arm or  2x “New 2x uper arm dummy 13”
    • 2x armor-knee
• White
  • 2x armor-forearm
  • 2x frame-forearm
  • GL_chest_insert
  • GL_eyes
  • frame hand grip left v8.stl (if you want to hold the lantern)
  • GL_hand_ring
    • This definitely need supports.  I also added a cylinder on the build plate that was taller than the model, so that the print ends on the cylinder instead of on the ring.
    • This one is oriented so that the ring is parallel to the bed, so that you can change the color to green at the end.  I'd recommend slowing down for those layers.
• Brown
  • hair
• Tan
  • GL_head