Skip to main content
F3D
Giá treo tường MicroJig GRR-RIPPER (Wall Mount Hanger) 1

3 images

DIY

Giá treo tường MicroJig GRR-RIPPER (Wall Mount Hanger)

By Vincent

Downloads
166
Likes
35
Views
647

Files 1 926.4 KB

  • MicroJig_GRR-RIPPER_Wall_Mount_Hanger_1776764260.stlSTL · 926.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#322369
Category
DIY
Published

Description

Hang your MicroJig GRR-RIPPER on a vertical surface with this snap-in mount. Features holes for #8 screws (#6 works ok, too) with the bottom one for adjustment to make it plumb. 

PLA has a bit more clutch force than PETG (due to the former having a higher bending modulus) and it feels good on the default 0.2mm profile. If you want the clutch force higher, use your favorite material with more perimeters and denser infill.

Print as-is, on the side, and without supports. This will align the layers properly. If you print it vertically, the flexing will risk layer separation.

I don't know what the effect cold creep will have on the clutch force long-term, but I will update this down the road with how each one holds up. There isn't much static stress on the part so I'm counting on it not meaningfully changing 🤞

Thanks to Siming for the original model for inspiration and geometry.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
926.4 KB
Largest file
926.4 KB

0 comments

See all