Skip to main content
F3D
The 100 Fanhead không cần supports 1

5 images

Máy In 3D

The 100 Fanhead không cần supports

Remix of THE 100 v1.0 - Máy in 3D nhanh nhất với khung in By MattThePrintingNerd

By Rhynier_476301

Downloads
217
Likes
36
Views
1,504

Files 3 2.8 MB

  • Toolhead_1776776777.stepSTEP · 2.5 MB
  • Fanhead_lower_1776776779.stlSTL · 115.1 KB
  • Fanhead_upper_1776776780.stlSTL · 204 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#322333
Category
Máy In 3D
Published

Description

This remixed version of the fanhead for The 100 printer allows me to

  1. print it without supports and
  2. fit the parts on a Voron 0 print bed

The only way I was able to do this was to split the fanhead into 2 pieces that then get assembled using 3 heat inserts and M3x6 screws. It does not have the clean look from the front as the original but I am happy with the trade-offs in order to achieve the above goals.

To print the parts without supports, rotate Fanhead_lower.stl 180 degrees so that it prints upside down. I would also recommend using a smooth print bed to maximize the seal between the 2 parts.

P.S. if you look closely you will notice that any overhangs that might have caused issues when printing without supports were changed to 45 degrees which most printers should handle without issue.

Read more Show less

Print spec

Formats
stepstl
Model files
3
Total size
2.8 MB
Largest file
2.5 MB

0 comments

See all