Skip to main content
F3D
Ống Đựng Bút Voronoi (Voronoi Pencil Holder) 1

1 image

DIY

Ống Đựng Bút Voronoi (Voronoi Pencil Holder)

By humebeam

Downloads
401
Likes
70
Views
1,251

Files 2 18.3 MB

  • voronoi-pencil-holder-1.1_1776755595.3mf3MF · 5 MB
  • voronoi-pencil-holder-1.0_1776755596.3mf3MF · 13.3 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Caution

If your printer and filament is not dialed in perfectly don't even attempt to print this model, it's not an easy print.

Support

All my designs and mods are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)

About

Everyone loves a good Voronoi diagram. So I made a pencil holder that prints without supports with minimal cleanup required, depending on printer and filament type. It does not use a lot of filament.

Print Settings

I recommend printing it in PLA as there are some challenging overhangs where it's beneficial with maximum parts cooling but it could print nicely in other filament types as well.

Supports should be disabled.

I've printed a couple on my Bambu Lab X1C and P1P printers and they printed very nicely in Prusament PETG, PLA and PolyMaker PolyTerra PLA without supports in around 3.5 hours each.

Read more Show less

Print spec

Formats
3mf
Model files
2
Total size
18.3 MB
Largest file
13.3 MB

0 comments

See all