Vách ngăn ngăn kéo Ikea MALM (Ikea MALM Divider)

Use this divider to separate your Ikea MALM drawers into separate spaces. This can be useful if you have your socks, pants and tops in one drawer but don't want them to mix up.

You need a build plate with at least 213mm length. No screws or glue is needed to connect the two divider halfs.

If you have calibrated your printer well enough and have good filament (e.g. eSUN PLA+), try the tight version. It has a really tight fit and holds the two pieces together without any wobbeling.

Otherwise you can use the connector version with a bit more tolerance. Keep in mind that this could mean that the divider will bend a bit more if you put in a lot of clothes.

If you already built your MALM, it is better to assemble the divider within the drawer and not outside. Otherwise you would have to remove your drawer from your MALM to be able to insert the divider into the drawer.

Recommended print settings:

• 0.4mm nozzle
• 0.2mm layer
• normal supports on build plate enabled (tip: if you have an AMS or similar, use PETG as a support interface filament with 0 z top distance)
• eSUN PLA+ Bone White filament for the perfect fit inside the drawer (I realized it after the print has finished that this would have been the perfect color choice)