Đèn LED ma quái Ghost Booh từ BODY3D cho Bambu Lab

I printed with:-
Material:Matte White PLA (Bambu Lab)
Infill:0%
Walls:2 (although 1 wall would allow better light transmission)

Layer/height modifier (0mm to 2mm):-
Infill:60%
Walls: 3
Material: Black PLA-ST (eSun) [This creates a bit of a floating look to the ghost]

I also added a (73.65mm x 7.34mm) disc modifier around the LED Base retention to increase the wall count in this area. See third picture for location, looking from under the model. 
Walls: 5

I'm waiting on my LED Lamp kit to arrive so I lit the ghost up with a torch for the photo. I expect the Bambu LED unit will not light up the ghost quite as much as this torch due to the wall thickness.

Edit 28/09/2023 - Bambu LED Kit 001 arrived today so this has been installed and the primary cover photo is now lit up using this. The amount of light given off by the LED Kit 001 is quite impressive and it gives a relatively warm (orange) glow.