Jeep Ducks - Monopoly Duck (Vịt Monopoly cho Jeep)

My wife recently got a Jeep Willis, and now she's on the Ducks in the Jeep train…
So I thought I would make a few custom ducks for here.  Here is the next one to come out.  Monopoly Duck.

I printed this at 0.1 mm with 5% infill, 3 perimeters walls.  
I have switched to Snug support to make sure things get supported well enough.  Seems that these supports come off nicely leaving very little scarring if any.

There are 2 versions.  One with the hat, monocle, beak and mustache separate, and one with them all together.  I personally find the separate pieces easier to print/finish/paint.  I also have 2 versions of the beak-mustache.  One with them printed together, and the other with the mustache separate.  It was pretty delicate to get off the print bed, so just incase others have issues with that small piece.  Lastly, if you print the monocle separately and like me, with transparent PETG, then crank the walls up to 10. The print comes out better that way than full infill.

I am now printing all my ducks with PETG (yellow since that is the worst color to paint).  I have also used an heat resistance overcoat to protect the paint.