Nắp Pickup Single Coil Guitar

This was a project I created when rebuilding a Squire Strat/Starcaster mashup.  You can judge that's fine; I used what parts I had to learn finishing, wiring and setup…free is the best when learning. :)

I've included hole templates so you can design your own.  This was created for the 48, 50, and 52-mm spaced pickups.

Printing Instructions:

• Measure the height of your pickup, you may need to scale. Not all pickups are the same. These worked for the two sets I have based on a Fender single coil.
• Material - Any, PLA is pictured
• Layer height - does not matter, the default .20mm in Prusa Slicer was used for the one pictured (.15 may give the slight curve a nicer appearance)
• Orientation - Recommend pickup front facing down on a smooth sheet.  You can print facing up, but if you want a glossy finish, you'll need to wet sand and use automotive rubbing compound to achieve it.  It's less work to achieve it printing pickup face down on the smooth sheet.
• Bottom (or top) fill pattern - Whatever suits your fancy.  You can achieve some cool effects based on the infill patterns.  (Pictured is Octagram Spiral)