Đế Suction Cup cho B Plugs

A base to hold plugs that come with a removable vibrating bullet. Fits set from Adam&Eve.com

The model prints easily with no support. 

I printed at 1.2 layer height, with somewhere between 25 and 50 percent infill, and 5 solid layers on the top, bottom, and sides to ensure the print would be very strong. (I tried printing it with only 3 shell layers and 20 percent infill and the peg snapped off easily, your results may vary.)

I toggled variable layer height in the slicer settings to get smoother curves, and ironing to smooth out the flat surfaces for easier cleaning/ sanitizing. 

After printing, I just needed to add 4 small off-the-shelf suction cups which I already had on hand.