Chân đế thay thế cho loa Harmon Kardon ONYX Studio

I used PLA dark wood filament it's good with my older HK ONYX Studio finish. 

Print upright as it stands, organic supports result in just some help with the low bridging. Draft mode for printing seemed fine because it's curvy - 15% infill of your choice.

The stand works, holding speaker at about original angle and the woofer cone thing at the back is free to do it's job - important for the ONYX.

You could probably put some foam pad on upper contact points to rule out any plastic to plastic rattle - I haven't yet and it sounds fine at most volumes.

Hope someone can use, glad to share different format if needed.