Đế sạc Apple Watch Ultra (Charging Stand)

This design is adjusted for the size of the Apple Watch Ultra (1 and 2).
It is made of 2 components, the Support and the Rubber base. The Rubber base also serve the purpose of holding the cable inside the support. I used Filaflex 70A for the Rubber base.

The assembly and disassembly of the charging pad can be facilitated by slightly warming the base with a hair dryer.

For the disassembly, you can push the charging pad out from the inside of the base with a screwdriver.

Version 2.1 takes the comments from @PiotrDworzyn_1650870  in account: Older Apple Watch charging cables are now compatible.

Version 2.2 takes the comments from @PiotrDworzyn_1650870  in account: Addition of 1 cut-out for the older generation charging pads and 1 cut-out underneath the Support to potentially add weight which would be hold in place by the Rubber base.