LED Cactus – Xương rồng LED

Print model 

• I used no supports on a Bambu, you might need them for underneath the pot if you don't have good cooling/bridging) 
• Fits on a Bambu but only if you rotate it correctly (as would be the case with other smaller printer beds)
• Prints great on my Voron 2.4 as well
• ~1 hour print

Solder usb leads to LED strip (use heat shrink to prevent shorting) 

insert the LED strip into the base (you may have to remove the rubber cap at the end), pull it all the way through, then push it into the channel.

I added a model of a pot so it looks a little nicer, it clips into place on the ‘cactus 2’ model. The only way i could get it to print reliably was using supports as shown in the pic.

5V 1M Green LED Strip

USB Pigtail (Male)